For more than 20 years, in the process of mobile phone development from 2G to 5G era step by step, the development process of mobile phone jammers corresponds to it. The Shengma brand interference equipment produced by our Nanjing Bokang Electromechanical Technology Co., Ltd. has also undergone numerous R&D, expansion and functional iterations. Among them, the way of modular assembly and combination of mobile phone jammers has been favored and recognized by customers more and more.

When it comes to modularity, in fact, many manufacturers also advertise that their products use modularity, but the modularity we point out here is different. In the past, the modularization of the mobile phone jammer refers to the modularization of each mobile phone frequency band inside the product. For example, the GSM900MHz frequency band is a separate PCB board module. The modules of many frequency bands are assembled into a mobile phone jammer to form a finished product. But in terms of the product as a whole, it is still a single form. There are some advantages to adopting this method. The advantages are that each frequency band module works independently, failure generally does not affect other modules, and each module can be disassembled and replaced. But the disadvantage is that when repairing or replacing the module, you need to open the shell of the whole machine, you need to remove the screws, apply heat-dissipating silicone grease, and need to use professional debugging instruments (such as spectrum splitter, RF power meter, RF signal attenuator, etc.), There is also a disadvantage when the total number of frequency band modules is fixed, which can only be replaced and cannot add multiple frequency bands.

Regarding the advantages and disadvantages of the traditional mobile phone jammer modular combination listed above, we have put forward a more advanced and reasonable design scheme of the mobile phone jammer modular combination through years of experience, and have fully realized the mass production of the product. The solution of our modular solution is: make each frequency band module directly into finished products, or directly complete the assembly and combination of finished product modules. There are no restrictions on the selection and combination of frequency bands, and the number of frequency band modules is not limited. any restrictions. Customers can remove or replace other mobile phone jammer modules at any time, and the removed modules can be assembled directly without debugging. It's like making a mobile phone jammer like a piece of Lego.