banner
blog
Home

blog

Notes on outdoor installation of mobile phone signal interferometer

Notes on outdoor installation of mobile phone signal interferometer

  • 2022/09/05

The location of the mobile phone signal interferometer installation varies according to the different requirements of the site. When installed outdoors, it is to interfere with the mobile phone signal in the open outdoor environment, generally in some places where a larger interference range is required. At this time, the high-power mobile phone signal jammer is generally used. And the high-power mobile phone interferometer will basically be equipped with a certain waterproof box as the case housing, as long as there is no water overflowing the box, basically there is no need to worry about the problem of water entering inside the box. Of course, when using high-power mobile phone signal interferer outdoors, it is not enough to only pay attention to waterproof, but also to deal with lightning protection. The way to prevent lightning is to weld the antenna bracket to the lightning rod, then insert a steel braze about 2 meters long into the ground, and weld one end of the steel brazing to the antenna bracket or lightning rod.

In some specific places, you want to interfere with the outdoor environment, but the interference distance is relatively small, so you can use a low-power mobile phone signal interferometer to install in the outdoor areas where you need to interfere. First of all, the small power mobile phone signal interferer does not need lightning protection, because the installation location is relatively low, the most important thing is to pay attention to rain protection. When designing the small power mobile phone interferer, some waterproof design has been made, but because the housing is not completely sealed and the waterproof capability is relatively weak, it is necessary to install a canopy above the small power mobile phone signal interferer, and equip the rainproof blinds around the interferer. The canopy size requirements exceed the size of the interferometer itself and extend about 15 centimeters in the front. However, to regularly check the operation of the mobile phone signal interferer, it is also important to note that the power supply cable connector is also waterproof so that it can be used normally.

"Shengma" signal interferometer | Nanjing Baikang Mechanical Technology Co., Ltd-ljw

Copyright © 2022 NanJing BoKang Electromechanical Technology CO.,LTD.All Rights Reserved.

IPv6 network supported

IPv6 network supported

top
NanJing BoKang Electromechanical Technology CO.,LTD

Send A Message

Send A Message

    If you are interested in our jammers and want to know more details,please leave a message here,we will reply you as soon as we can.

  • #
  • #
  • #