
How important is the standardized installation of high-power drone signal jammers?
With the increasing requirements of the drone defense range, some customers must choose to install high-power drone signal jammers in the protection area of their units. When such drone countermeasure equipment is used, a Only one device can increase the protection radius to more than 3Km. Converted to the coverage area, it can effectively protect 20-30 square kilometers. However, high-power drone signal jammers, reasonable installation positions and correct installation methods are very important, and there are many important concerns in installation specifications:
1. Try to install the drone signal jammer on the roof of the building in the central area of the unit, and the height of the building is preferably higher than other buildings. In this way, when the signal of the drone signal jammer is transmitted omnidirectionally, there will be no signal attenuation or signal reflection and refraction due to the obstruction of the building.
2. Even if the building already has a lightning protection device, it is still necessary to set up a separate lightning rod for the drone signal jammer, and the lead between the lightning rod and the ground should not be mixed with the ground wire of the building. , it should be connected to the earth with a separate cable. Note: The height of the lightning rod must exceed the antenna by 1-2 meters, and the lightning rod should maintain a certain safe distance from the antenna and the host of the drone signal jammer.
3. The base, pole, etc. used to install the host and antenna of the drone signal jammer must be firmly fixed on the concrete floor or base on the roof. In order to prevent shaking due to strong winds, the equipment support must be 100% If necessary, cables in multiple directions should be configured to increase the wind resistance of the entire system.
4. In order to ensure that the drone signal jammer can work continuously for many years, the connecting cables and connectors between various components must be protected by waterproof, insulation and other protection measures. If conditions permit, install a set of glass fiber reinforced plastic for the antenna. The protective cover is a very good protection measure.
Copyright © 2025 NanJing BoKang Electromechanical Technology CO.,LTD.All Rights Reserved.
IPv6 network supported