The online mobile phone signal jammer system is usually installed in schools, prisons, large conference centers and other places, because when these units interfere with mobile phone signals, they need to cover a very large area and involve multiple buildings, multiple The coverage of the interference signal in the room adopts the cellular networking method, which will inevitably require a large number of interference equipment terminals. It is very common for such customer units to install dozens or even hundreds of jamming devices. The next question arises. After the jammer system is delivered to the customer and put into use normally, what about the online version of the mobile phone signal jammer system? What about troubleshooting and analysis?

First of all, the manufacturer of the jammer system will give a standardized guidance document, and will require customers or agents to point out full-time maintenance personnel to regularly check the online version of the mobile phone signal jammer system according to the requirements of the guidance document, and will check The results are registered and fed back to the customer's leader in charge, so as to determine whether further maintenance or replacement is required.

Maintenance personnel can use the main control software of the mobile phone signal jammer system on the Internet to quickly query the working status and fault status of each mobile phone signal jamming terminal in the system. The status query of the signal jamming terminal should at least include: equipment Remote start-up, shutdown, power adjustment and other functions can respond quickly, and can perform on-off control or power adjustment for each interference module in the device.

The above-mentioned status query should be applied to every interference point in the entire mobile phone signal jammer system. After checking all the interference points, you will get a complete maintenance report, from which you can clearly know which specific interference devices have failed. Here we need to remind the maintenance personnel that the fault points detected by the main control software of the jammer system can complete normal network communication with the jamming terminal. In fact, there may be another possibility, that That is, there is a network failure between some interference terminals and the main control server, which makes the main control software unable to complete the sending and uploading of terminal data. When encountering such a problem, a special prompt message of network communication interruption will appear on the main control software. The maintenance personnel must first check and solve the problem of smooth network transmission.