
What should I pay attention to when installing mobile phone signal jammer in the meeting room?
The installation steps of the mobile phone signal jammer in the meeting room are not complicated, but before installation, we should pay attention to a few small details, because these determine whether the use effect of the mobile phone signal jammer can be maximized in the later stage, or whether it will interfere with other electrical devices, such as the environment near the installation site, and the installation height.
1. The manufacturer recommends that the mobile phone signal jammer in the meeting room be installed at more than 2 meters, which can prevent man-made damage to a certain extent, and the interference effect can reach the best. Use the installation accessories configured by the manufacturer, the hole size drawing, the hole drilling on the wall, and the expansion pipe and screw can be fixed on the wall. Then you can lay the power cord.
2. If there is a ceiling in the conference room, the cell phone signal jammer in the conference room can also be placed in the ceiling. Before placing, the ceiling material should be determined first. If it is wood, asbestos board, gypsum board and other non-metallic materials, they can be placed directly inside. If the ceiling is made of metal, the jammer is not suitable to be placed on the ceiling. This is because the jamming signal emitted by the jammer will be seriously attenuated when it penetrates the metal ceiling, and some frequency bands may not even penetrate the ceiling, resulting in very poor jamming effect of the jammer.
3. Whether it is wall-mounted installation or concealed installation on the ceiling, it is better not to have other electronic equipment within half a meter of the jammer, such as audio, video camera, audio and video cable, etc.
4. After the jammer is installed, connect the power cord reliably, then power the signal jammer and turn on the power switch of the shield. Observe whether the power indicator on the housing panel of the mobile phone signal jammer host is normal. If the power indicator is not on, please contact the equipment supplier in time.
Copyright © 2025 NanJing BoKang Electromechanical Technology CO.,LTD.All Rights Reserved.
IPv6 network supported